This page is used for configuring the device operation mode

Gateway

The standard router operation mode: NAT is enabled, DHCP server on LAN and DHCP client on WAN are running

Bridge

The device is fully bridged, all the interfaces (LAN and WAN) are bound in the link layer, NAT is disabled

This page is used for configuring the device WAN port speed settings

Auto-negotiation

The automatic full duplex/half duplex mode setting with automatic data rate configuring by Ethernet nodes using IEEE 802.3 technology

Auto-negotiation, full

The full duplex mode with automatic data rate configuring by Ethernet nodes using IEEE 802.3 technology

1000M, full

The full duplex mode with data rate up to 1 Gbit/s

100M, full

The full duplex mode with data rate up to 100 Mbit/s

100M, half

The half duplex mode with data rate up to 100 Mbit/s

100M, auto-negotiation

The automatic full duplex/half duplex mode setting with data rate up to 100 Mbit/s

10M, full

The full duplex mode with data rate up to 10 Mbit/s

10M, half

The half duplex mode with data rate up to 10 Mbit/s

10M, auto-negotiation

The automatic full duplex/half duplex mode setting with data rate up to 10 Mbit/s

This page is used for configuring PPTP VPN

PPTP VPN

Enabling PPTP tunnel

Server

PPTP Server Address

User Name

The user name for authorization on the PPTP server

Password

The password for authorization on the PPTP server

Authentication

PPTP Server Authentication Method:

• Auto — automatic selection of authentication type depending on the server
• PAP (Password Authentication Protocol) — is a verification protocol that sends the username and password to the authentication server without encryption
• CHAP (Challenge Handshake Authentication Protocol) — negotiation verification protocol the user's password is encrypted and authentication occurs in three steps
• CHAPMSV2 — verification protocol with negotiation and mutual exchange verifications of the Server and the Client

Encryption

Selecting an encryption type

Default Gateway

When checked, the default route will be set through the configured PPTP tunnel

This page is used for configuring L2TP VPN

L2TP VPN

Enabling L2TP tunnel

Server

L2TP Server Address

L2TP Tunnel Authentication

When checked, the L2TP tunnel authentication will be enabled

L2TP Tunnel Authentication Secret

The L2TP tunnel authentication key

PPP Authentication

• Auto — automatic selection of authentication type depending on the server;
• PAP (Password Authentication Protocol) is a verification protocol that sends the username and password to the authentication server without encryption;
• CHAP (Challenge Handshake Authentication Protocol) — negotiation verification protocol the user's password is encrypted and authentication occurs in three steps;
• CHAPMSV2 — verification protocol with negotiation and mutual exchange verifications of the Server and the Client.

PPP Encryption

PPP encryption type

User Name

The user name for authorization on the L2TP server

Password

The password for authorization on the L2TP server

PPP Connection Type

Selecting the PPP connection type:

• Persistent — the PPP tunnel is set up permanently;
• Dial-on-Demand — the PPP tunnel is set up in case the network activity is detected and is set down in case of its absense due to idle time;
• Manual — the PPP tunnel is set up manually with the help of the buttons «Connect/Disconnect».

Idle Time

The time specifying the inactive PPP connection to go down

Default Gateway

When checked, the default route will be set through the configured L2TP tunnel