This page is used for configuring the device operation mode

Gateway

The standard router operation mode: NAT is enabled, DHCP server on LAN and DHCP client on WAN are running

Bridge

The device is fully bridged, all the interfaces (LAN and WAN) are bound in the link layer, NAT is disabled

This page is used for configuring the device WAN port speed settings

Auto-negotiation

The automatic full duplex/half duplex mode setting with automatic data rate configuring by Ethernet nodes using IEEE 802.3 technology

Auto-negotiation, full

The full duplex mode with automatic data rate configuring by Ethernet nodes using IEEE 802.3 technology

1000M, full

The full duplex mode with data rate up to 1 Gbit/s

100M, full

The full duplex mode with data rate up to 100 Mbit/s

100M, half

The half duplex mode with data rate up to 100 Mbit/s

100M, auto-negotiation

The automatic full duplex/half duplex mode setting with data rate up to 100 Mbit/s

10M, full

The full duplex mode with data rate up to 10 Mbit/s

10M, half

The half duplex mode with data rate up to 10 Mbit/s

10M, auto-negotiation

The automatic full duplex/half duplex mode setting with data rate up to 10 Mbit/s

This page is used for configuring PPTP VPN

PPTP VPN

Enabling PPTP tunnel

Server

PPTP Server Address

User Name

The user name for authorization on the PPTP server

Password

The password for authorization on the PPTP server

Authentication

PPTP Server Authentication Method:

• Auto — automatic selection of authentication type depending on the server
• PAP (Password Authentication Protocol) — is a verification protocol that sends the username and password to the authentication server without encryption
• CHAP (Challenge Handshake Authentication Protocol) — negotiation verification protocol the user's password is encrypted and authentication occurs in three steps
• CHAPMSV2 — verification protocol with negotiation and mutual exchange verifications of the Server and the Client

Encryption

Selecting an encryption type

Default Gateway

When checked, the default route will be set through the configured PPTP tunnel