Router Management Utility

Router storage full (read only) or is mounted in volatile storage (RAM). It will not function correctly, or will revert to a previous state after rebooting. Restore default configuration or flash new firmware (without preserving settings).

Upgrade Firmware

Current Gargoyle Version:

Select Firmware File:

Enter hash (MD5/SHA-1/SHA-256): (optional)

Firmware upgrade will not start until confirmed on the next page.

Confirm Upgrade

By default upgrading your firmware will completely erase your current configuration. It is strongly recommended that you back up your current configuration before performing an upgrade.

You can attempt to preserve your old settings by ticking Attempt to Preserve Settings below. Be aware that this can potentially lead to problems if the new version is significantly newer than the old version, but for small, incremental differences this will likely work. It is always best to keep a backup just in case.

Valid firmware:

Firmware matches device:

Supported devices:

Firmware/Device Compatibile:

Firmware fits in flash memory:

Checksum matches:

MD5:
SHA-1:
SHA-256:

Preserve settings is not allowed with this firmware

Attempt to Preserve Settings:

Firmware has been detected as incompatible with this device (wrong device OR too big OR invalid firmware format). Forcing firmware upgrade can result in a bricked device if used incorrectly. Please ensure this firmware is correct for your device!

If you wish to force the upgrade, please tick Force upgrade below.

Force upgrade: