| Admin Password: |
(purposely not displayed for security protection) |
| G723 rate: |
6.3kbps encoding rate
5.3kbps encoding rate |
| iLBC frame size: |
20ms
30ms |
| iLBC payload type: |
(between 96 and 127, default is 97) |
| Silence Suppression: |
No
Yes |
| Voice Frames per TX: |
(up to 10/20/32/64 for G711/G726/G723/other codecs respectively)
|
| Layer 3 QoS: |
(Diff-Serv or Precedence value) |
| Layer 2 QoS: |
802.1Q/VLAN Tag
802.1p priority value
(0-7) |
| Data VLAN Tag: |
1:
2:
3:
(can't use the same non-zero value as 802.1Q tag)
|
| No Key Entry Timeout: |
(in seconds, default is 4 seconds) |
| Use # as Dial Key: |
No
Yes |
| local RTP port: |
(1024-65400, default 5004, must be even) |
| Use random port: |
No
Yes |
| keep-alive interval: |
(in seconds, default 20 seconds) |
| Use NAT IP: |
(if specified, this will be used in SIP/SDP message) |
| STUN server: |
(URI or IP:port) |
Firmware Upgrade and
Provisioning: |
Upgrade Via
TFTP HTTP
Firmware Server Path:
Config Server Path:
Firmware File Prefix:
Firmware File Postfix:
Config File Prefix:
Config File Postfix:
Allow DHCP Option43 and Option 66 to override server:
No
Yes
Automatic Upgrade:
No
Yes, check for upgrade every
minutes (default 7 days)
Always Check for New Firmware
Check New Firmware only when F/W pre/suffix changes
Always Skip the Firmware Check
Authenticate Conf File:
No
Yes (cfg file would be authenticated before acceptance if set to Yes)
|
| Phonebook XML Download: |
Enable Phonebook XML Download:
No
YES, HTTP
YES, TFTP
Phonebook XML Server Path:
Phonebook Download Interval: (0-720, in minutes)
Remove Manually-edited entries on Download:
No
Yes
|
| LDAP Directory: |
LDAP Script Server Path:
|
| Idle Screen XML Download: |
Enable Idle Screen XML Download:
No
YES, HTTP
YES, TFTP
Download Screen XML At Boot-up:
No
Yes
Use custom filename:
No
Yes
Idle Screen XML Server Path:
|
| XML Application: |
Server Path:
Softkey Label:
|
| Offhook Auto Dial: |
(User ID/extension to dial automatically when offhook, max length 35)
|
| DTMF Payload Type: |
|
| Syslog Server: |
|
| Syslog Level: |
|
| NTP Server: |
(URI or IP address)
Allow DHCP Option 42 to override NTP server:
No
Yes
|
| Public Mode: |
No
Yes |
| Distinctive Ring Tone: |
Custom ring tone 1, used if incoming caller ID is
Custom ring tone 2, used if incoming caller ID is
Custom ring tone 3, used if incoming caller ID is
|
| System Ring Tone: |
|
| Call Progress Tones: |
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
|
| Intercom User ID: |
(Account 1)
|
| Disable Call-Waiting: |
No
Yes |
| Disable Call-Waiting Tone: |
No
Yes |
| Disable Direct IP Calls: |
No
Yes |
| Use Quick IP-call mode: |
No
Yes |
| Disable Conference: |
No
Yes |
| Lock Keypad Update: |
No
Yes (configuration update via keypad is disabled if set to Yes) |
| Enable MPK sending DTMF: |
No
Yes |
| Disable DND Button: |
No
Yes (DND button pressing will have no effect if set to Yes) |
| Disable Transfer: |
No
Yes |
| Disable Multicast Filter: |
No
Yes |
| Enable Constraint Mode: |
No
Yes |
| Semi-attended Transfer Mode: |
RFC5589
Send REFER with early dialog |
| Headset Port Type: |
2.5mm
RJ22
|
| Headset TX gain (dB): |
|
| Headset RX gain (dB): |
|
| Display Language: |
English
Chinese
Secondary Language
(Language File postfix) |
|
|