Setup Wizard The setup wizard will guide you to configure access point for first time. Please follow the setup wizard step by step. Welcome to Setup Wizard. The Wizard will guide you the through following steps. Begin by clicking on Next. 1. Operation Mode You can setup different modes to LAN and WLAN interface for NAT and bridging function. Gateway: In this mode, the device is supposed to connect to internet via ADSL/Cable Modem. The NAT is enabled and PCs in four LAN ports share the same IP to ISP through WAN port. The connection type can be setup in WAN page by using PPPOE, DHCP client, PPTP client, L2TP client or static IP. Bridge: In this mode, all ethernet ports and wireless interface are bridged together and NAT function is disabled. All the WAN related function and firewall are not supported. Wireless ISP: In this mode, all ethernet ports are bridged together and the wireless client will connect to ISP access point. The NAT is enabled and PCs in ethernet ports share the same IP to ISP through wireless LAN. You must set the wireless to client mode first and connect to the ISP AP in Site-Survey page. The connection type can be setup in WAN page by using PPPOE, DHCP client, PPTP client, L2TP client or static IP. 2. Time Zone Setting You can maintain the system time by synchronizing with a public time server over the Internet. Enable NTP client update Automatically Adjust Daylight Saving Time Zone Select : NTP server : 192.5.41.41 - North America 192.5.41.209 - North America 208.184.49.9 - North America 131.188.3.220 - Europe 130.149.17.8 - Europe 203.60.1.2 - Australia 203.117.180.36 - Asia Pacific 3. LAN Interface Setup This page is used to configure the parameters for local area network which connects to the LAN port of your Access Point. Here you may change the setting for IP addresss, subnet mask, DHCP, etc.. IP Address: Subnet Mask: 4. WAN Interface Setup This page is used to configure the parameters for Internet network which connects to the WAN port of your Access Point. Here you may change the access method to static IP, DHCP, PPPoE, PPTP or L2TP by click the item value of WAN Access type. WAN Access Type: Static IP DHCP Client PPPoE PPTP L2TP /*-- keith: add l2tp support. 20080515 */ IP Address: Subnet Mask: Default Gateway: User Name: Password: IP Address: Subnet Mask: Server IP Address: User Name: Password: IP Address: Subnet Mask: Server IP Address: User Name: Password: User Name: Password: PIN: APN: Dial Number: Attain DNS Automatically Set DNS Manually DNS :
1. Set Wireless Network Name You can enter the Wireless Network Name of AP. Wireless Network Name(SSID): 2. Select Wireless Security Mode This page allows you setup the wireless security. Turn on WEP or WPA by using Encryption Keys could prevent any unauthorized access to your wireless network. Encryption: None WEP WPA WPA2 Key Length: 64-bit 128-bit Key Format: ASCII Hex Key Setting: Pre-Shared Key Format: Passphrase Hex (64 characters) Pre-Shared Key: Authentication Mode: Enterprise (AS Server) Personal (Pre-Shared Key) Pre-Shared Key Format: Passphrase HEX (64 characters) Pre-Shared Key: AS Server IP Address:
1. WAN Interface Setup This page is used to configure the parameters for Internet network which connects to the WAN port of your Access Point. WAN Access Type: PPPoE IP Address: Subnet Mask: Default Gateway: User Name: Password: IP Address: Subnet Mask: Server IP Address: User Name: Password: IP Address: Subnet Mask: Server IP Address: User Name: Password: DNS :