Grandstream Device Configuration
STATUS BASIC SETTINGS ADVANCED SETTINGS ACCOUNT
Admin Password:   (purposely not displayed for security protection)
G723 rate:   6.3kbps encoding rate       5.3kbps encoding rate
iLBC frame size:   20ms       30ms
iLBC payload type:   (between 96 and 127, default is 97)
Silence Suppression:   No      Yes
Voice Frames per TX:   (up to 10/20/32/64 for G711/G726/G723/other codecs respectively)
Layer 3 QoS:   (Diff-Serv or Precedence value)
Layer 2 QoS :   802.1Q/VLAN Tag     802.1p priority value (0-7)
No Key Entry Timeout:   (in seconds, default is 4 seconds)
Use # as Dial Key:   No      Yes
local RTP port:   (1024-65400, default 5004, must be even)
Use random port:   No      Yes
keep-alive interval:   (in seconds, default 20 seconds)
Use NAT IP:   (if specified, this will be used in SIP/SDP message)
STUN server:   (URI or IP:port)
Firmware Upgrade and
Provisioning:
  Upgrade Via     TFTP     HTTP
          Firmware Server Path:
          Config Server Path:

          Firmware File Prefix:
          Firmware File Postfix:
          Config File Prefix:    
          Config File Postfix:    

  Allow DHCP Option 66 to override server:
    No     Yes

  Automatic Upgrade:
    No     Yes, check for upgrade every minutes (default 7 days)

    Always Check for New Firmware
    Check New Firmware only when F/W pre/suffix changes
    Always Skip the Firmware Check

  Authenticate Conf File:
    No     Yes   (cfg file would be authenticated before acceptance if set to Yes)
Offhook Auto Dial:   (User ID/extension to dial automatically when offhook)
DTMF Payload Type:  
Onhook Threshold:  
Syslog Server:  
Syslog Level:  
NTP Server:   (URI or IP address)
  Allow DHCP Option 42 to override NTP server:
    No     Yes
Distinctive Ring Tone:   Custom ring tone 1, used if incoming caller ID is
  Custom ring tone 2, used if incoming caller ID is
  Custom ring tone 3, used if incoming caller ID is
System Ring Tone:  
Call Progress Tones:
Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
Busy Tone
Reorder Tone
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
Disable Call-Waiting:   No      Yes
Disable Direct IP Calls:   No      Yes
Use Quick IP-call mode:   No      Yes
Disable Conference:   No      Yes
Lock Keypad Update:   No      Yes   (configuration update via keypad is disabled if set to Yes)
Disable DND Button:   No      Yes   (MUTE/DEL button pressing will have no effect if set to Yes)
Disable Transfer:   No      Yes
Send Flash Event:   No      Yes
Headset TX gain (dB):  
Headset RX gain (dB):  
 
     
All Rights Reserved Grandstream Networks Inc. 2004-2009